|
|
|
PRM Products Swingarm Plate Installation
|
|
|
| 1) Installation of the PRM Products Swingarm Plate
is very simple and straight forward. Raise the back end up off the ground, and remove the brake capaler. |
2) Losen axle retaning nut. (10mm
bolt)Then turn axle lock nut clock wise to losen, slide washer into expose retainer clip.Remove clip, slide washer
out then turn nut counter clockwise to remove. |
|
|
|
| 3) Now slide the brake disk assembly
out toward the wheel. Remove stock protector, install the PRM protector starting on the left side. |
4) Sliding the axle assembly to the
right will give you access to the bolts on the right side. |
|
|
| 5) Your almost done
now just reverse steps 4-1. |
|
|