Reviews: Hinson Complete Clutch Package 

Billet Inner Hub And Pressure Plate 8-Plate Kit Installation Instructions

1) Remove the stock cover by breaking the cover loose with a large screw driver on the back tab of the cover.

2) Remove the bolts and the springs from the clutch assembly. Remove the pressure plate, and actuator pin, But don't remove the plates leave them in the bike.



3) Remove the main shaft nut using an air impact gun.

4) You can now remove the fiber plates, metal plates, and inner hub.

5) Now put the Hinson inner hub into the bike.

6) Reinstall the washers and make sure that the washer marked "outside" is facing outside. Clean the threads of the main shaft and put a drop or two of blue Loctite on the threads. Reinstall the main shaft nut and tighten it down to 47 ft/lbs.
NOTE: Crimp the lock nut on the main shaft.

7) Soak the plates in oil and then install
them into the assembly, install the 8 fiber and 7 steel plates.

Do not use the old 400EX plates, you need to get new plates from Honda for this kit to work, these part numbers are:

 Fiber plates: 22201-MAL-600 or 22201-KAE-000

 Steel plates: 22321-KFO-770 or Hinson part # H103

8) Remove the bearing from the stock plate using a socket and vice to push the bearing out. Now install it into the Hinson pressure plate. 

9) Install the pressure plate, springs, and bolts.

10) Reinstall the stock cover using the stock bolts

11) Adjust the cable so there is 1/8" to 1/4" of free play in the cable.

[Click here] for Quick Change Clutch Cover Installation Instructions.

 Hinson Racing
1630 W. 11th St.
Upland, Ca. 91786
909-946-2942
[http://www.hinsonracing.com/]