 |
Reviews:Graydon Proline
"Elite" Nerf Bars
This time around we install a set of
"Elite" Nerf Bars from Graydon
Proline.
Graydon Proline "Elite" Nerf
Bars Installation
1)Check for aluminum burrs
inside the front nerf bar tubes and on
the front mount bar. Apply heavy grease
before inserting front bar into tubes. To
prevent scratching front frame - apply
duct tape to frame before installation
remove duct tape when installation is
completed.
| 2)Lay the
nerf bar webbing on the ground
below the nerf bars to determine
the proper side and positioning
The single notably longer strap
runs lengthwise to the ATV and
goes to the rear none of the
straps mount to the frame. For
the looped webbing mounts, the
strap is threaded down through
the top slot continuing through
the bosom slot. Now loop the
strap end forward and insert it
through the front of the middle
slot then back up through to top
slot, where it will be underneath
the main webbing strap. With the
flat dual slot webbing mount (one
on each side )slip the strap down
through to rear slot, then up
through the forward slot. After
all the straps are threaded,
adjust the webbing alignment
making sure none of the straps
interfere with either the shift
lever or brake pedal. |
|
| 3)Position
one nerf bar on the machine.
Place the forward nerf tube on
top of the lower frame tube. Line
up the rear mounting flange in
front of the footpeg. Insert the
front frame mount through the
frame and into the nerf bar
repeat this step on the other
side. Thread loosely but do not
lighten yet. |
|
| 4) The width of the
bars is adjustable according to
where the flange is placed on the
peg. When correctly positioned,
clamp the flange to the footpeg
with a vise grip or C-
clamp.Using a 1/4" drill bit
in an electric drill, make two
holes in the mounting flange,
continuing on through the nearest
side of the footpeg. Repeat for
the opposite side.Check width of
nerf bars. 
5)When correct, mark
top and bottom holes on the front
frame mount .Then drill all 4
holes using a 5/16" drill
bit. After the holes have been
drilled and the nerfs
reassembled, insert the 8mm
button head cap bolts to secure
the nerfs and the front mounting
bracket, making sure to put the
8mm nylock nuts on the bottom.
Tighten all bolts.
|
15935 Minnesota Ave.
Paramount Ca. 90713
Information Line (562)
531-7142
Order Line (800) 655-7762
Fax Line (562) 531-7058
[http://www.graydonproline.com/]
|
|
